Other
“Microlathe is a little dremel-powered woodturning/watchmaker’s lathe that can be printed and bolted together with all those leftover M3 nuts and bolts that came with your Makerbot. In addition to the M3 nuts/bolts, you only require a …
“This is a simple holder for coin cells. I printed it so I could easily store coin cells in small drawers without the coin cells touching and probably shortening. The presets for the holder are a rather loose fit. Other …
“Do not use clamps with square corners! Rounded corners in twice stronger then square corners! customize your own sizes in code”
“Inspired by the amazing PCB Workstation (http://www.thingiverse.com/thing:801279) I used the PCB holder part and simplified the base for quick printing. Instead of the butterfly nuts I used this knob. Keep in mind, the short legs …
“Toy Printing Press. Put some finger paint on the first roll (tip: wrap with some Cloth) then insert the stamp-slider until the stop position (given by lever), push a paper strip through the intake until it goes through the slit …
“Calendário Enigma, conforme vc gira o disco de dia e data ele forma as iniciais do mês e o dia, olhando o restante do disco não conseguimos identificar os numeros e meses, somente quando o conjunto está sobre o campo …
“This is a simple and performant library for drawing wedges with no artifacts (e.g. no clipping/mask rectangles or similar) as well as wedges greater than 180 degrees. It does this using polygon() and some hacky-but-elegant flattening and re-creating …
“Car toy with windup motor.”
“As I did not find a cable chain suiting my needs, I decided to make my own. I was looking for a fully parametric cable chain, capable of output in CSG. The Cable Chains I found here were mostly only …
“This is a maze generator, implemented by pure OpenSCAD. It would generate a different maze every time.”